![L298n stepper motor driver controller board module manual](https://kumkoniak.com/30.jpg)
- #L298n stepper motor driver controller board module manual driver
- #L298n stepper motor driver controller board module manual code
#L298n stepper motor driver controller board module manual driver
The aim of the Raspberry Pi L298N Motor Driver Module Interface is just to understand the concept behind controlling a simple DC Motor with Raspberry Pi.I think the commands are self-explanatory. e – exit (to stop the motor and exit Python).h – high (to increase the speed to 75% level).m – medium (to run the motor at medium speed 50%).l – low (to decrease the speed to 25%) – default speed.b – backward (to reverse the direction of rotation).f – forward (to run the motor in forward direction) – default direction.
![l298n stepper motor driver controller board module manual l298n stepper motor driver controller board module manual](https://i.ebayimg.com/images/g/ak0AAOSww~heTb~2/s-l600.jpg)
This is followed by a list of commands you must use to control the motor. You will get a message regarding the default speed and direction of the Motor. After creating the Python Script with the above code, run the script.
#L298n stepper motor driver controller board module manual code
If you take a look at the code carefully, you can easily understand the working of the project. We will see the explanation of the code in the Working Section. The Python Script for Interfacing L298N Motor Driver Module with Raspberry Pi is given below. The rest of the job is done by the Python Script. In order to do that, connect the ENA pin of L298N to Physical Pin 22 (GPIO25) of Raspberry Pi.Ĭoming to the Inputs of the Motor, connect the IN1 and IN2 of L298N Module to Physical Pins 16 and 18 (GPIO23 and GPIO24). Now, since we are controlling a single DC Motor, we need to use a single channel of the L298N. Then, make the GND terminals of Raspberry Pi and L298N Motor Driver Module common (connect them together).
![l298n stepper motor driver controller board module manual l298n stepper motor driver controller board module manual](https://i.pinimg.com/originals/1d/0c/60/1d0c60eb274e5ee6583bf5bbe6f255ab.jpg)
First connect 12V Power Supply to L298N Motor Driver Module. Driving current: 2A (MAX single bridge) Storage temperature: -20 to +135. The design of the Raspberry Pi L298N Motor Driver Interface Circuit is very simple. Work mode: H bridge drive (double road) Main control chip: L298N.
![l298n stepper motor driver controller board module manual l298n stepper motor driver controller board module manual](https://ae01.alicdn.com/kf/HTB163w1QFXXXXa_aXXXq6xXFXXXF/Rotoup-L298N-Stepper-Motor-Driver-Controller-Board-Module-Dual-ponte-H-Bridge-DC-for-Arduino-smart.jpg)
If you remember, I have already made a project on CONTROLLING A DC MOTOR WITH RASPBERRY PI using L293D Motor Driver.
![l298n stepper motor driver controller board module manual l298n stepper motor driver controller board module manual](https://fruitlasopa972.weebly.com/uploads/1/2/6/3/126322806/446474810.jpg)
When I say control a DC Motor, I mean you can start a motor, stop it, make it rotate in forward direction, backward directions, increase the speed of rotation and also decrease the speed.įor this, I’ll be using the L298N Motor Driver Module. Interfacing L298N Motor Driver Module with Raspberry Pi will allow us to control a DC Motor (in fact, you can control two DC Motors).
![L298n stepper motor driver controller board module manual](https://kumkoniak.com/30.jpg)